Specifications

4-26 Port Commands
set port type wired-auth
ConfiguresaRoamAboutswitchportforawiredauthenticationuser.
Syntax
set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none }]
Parameters
Defaults
Thedefaulttag‐listisnull(notagvalues).Thedefaultnumberofsessions is 1.Thedefaultfall thru
authenticationtypeisnone.
Mode
Enabled.
Usage
Youcannotsetaport’stypeiftheportisamemberofaportVLAN.Toremoveaportfroma
VLAN,usetheclearvlancommand.Toresetaportasanetworkport,usetheclear porttype
command.
Whenyouchangeporttype,MS Sappliesdefaultsettings
appropriatefortheporttype.Table 4‐5
liststhedefaultsettingsthatMSSapplieswhenyousetaport’stypetoap.
Note: Before changing the port type from ap to wired-auth or from wired-auth to ap, you must
reset the port with the clear port type command.
port‐list Listofphysicalports.
tag‐list Oneormorenumbersbetween1and 4094thatsubdivide awired
authenticationportintovirtualports.
num Maximumnumberofsimultaneoususersessionssupported.
last‐resort Automaticallyauthenticatestheuser,withoutrequiring ausernameand
password.
none Deniesauthenticationandprohibitstheuserfromaccessing
thenetwork
overthisport.
web‐portal ServestheuserawebpagefromtheRoamAboutSwitch’snonvolatile
storageforsecurelogintothenetwork.
Table 4-5 Wired Authentication Port Defaults
Port Parameter Setting
VLAN membership Removed from all VLANs. You cannot assign an AP access port to a
VLAN. MSS automatically assigns AP access ports to VLANs based on
user traffic.
Spanning Tree Protocol (STP) Not applicable
802.1X Uses authentication parameters configured for users.
Port groups Not applicable