Specifications

RoamAbout Mobility System Software Command Line Reference 4-25
set port trap
EnablesordisablesSimpleNetworkManagementProtocol(SNMP)linkupandlinkdowntrapson
anindividualport.
Syntax
set port trap port-list {enable | disable}
Parameters
Defaults
SNMPlinkupandlinkdowntrapsaredisabledbydefault.
Mode
Enabled.
Usage
Thesetporttrapcommandoverridestheglobalsettingofthesetsnmptrapcommand.
Thesetporttypecommanddoesnotaffecttheglobaltrapinformationdisplayedbytheshow
snmpconfigurationcommand.Forexample,ifyougloballyenablelinkupandlinkdowntraps
butthendisablethetrapsona
singleport,theshowsnmpconfigurationcommandstillindicates
thatthetrapsaregloballyenabled.
Example
ThefollowingcommandenablesSNMPlinkupandlinkdowntrapsonports17and18:
RBT-8100# set port trap 17-18 enable
Related Commands
• setipsnmpserveronpage 7 ‐36
• setsnmpcommunityonpage 7‐44
• setsnmptraponpage 7‐58
• setsnmptrapreceiveronpage 7‐59
• showsnmpconfigurationonpage 7‐87
port‐list Listofphysicalports.
enable EnablestheTelnetserver.
disable DisablestheTelnetserver.