Specifications

RoamAbout Mobility System Software Command Line Reference 4-15
set dap
ConfiguresaDistributedaccesspointforanAccessPointthatisindirectlyconnectedtothe
RoamAboutswitchthroughanintermediateLayer 2orLayer 3network.
Syntax
set dap dap-num serial-id serial-ID model {AP3000} [radiotype {11a | 11b| 11g}]
Parameters
Defaults
ThedefaultradiotypeformodelAP3000is802.11g.
Accesspointradiosconfiguredfor802.11galsoallowassociationsfrom802.11bclientsbydefault.
Todisablesupportfor802.11bassociations,usethe setradio‐profile11g‐onlycommandonthe
radioprofilethatcontainstheradio.
Accesspoint‐3xxmodelshavean
internal802.1b/gantennaaswellasaconnectorforanexternal
antenna,souseofanexternalantennaisoptionalonthesemodels.TheRBT‐1602alsohasa 
connectorforanoptionalexternal802.11aantenna.Tospecifytheantennamodel,usetheset{ap|
dap}radioantennatypecommand.
Mode
Enabled.
Notes: Before configuring a Distributed access point, you must use the set system countrycode
command to set the IEEE 802.11 country-specific regulations on the RoamAbout switch. See set
system countrycode on page 3-16.
dap‐num NumberfortheDistributedaccesspoint.
Therangeofvalidconnectionnumbersdependsonthe
RoamAboutswitchmodel:
•ForanRBT‐8400,youcanspecifyanumberfrom1to20.
serial‐idserial‐ID AccesspointserialID.TheserialIDislistedontheaccess
pointcase.Todisplay
theserialIDusingtheCLI,usethe
showversiondetailscommand.
model{AP3000} Accesspointmodel.
radiotype11a | 11b | 11g Radiotype:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g
Note: This option applies only to single-radio models.