Specifications

RoamAbout Mobility System Software Command Line Reference 24-15
reset
ResetsaRoamAboutswitch’shardware.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Bootprompt.
Usage
Afterresettingthehardware,theresetcommandattemptstoloadasystemimagefileonlyifother
bootsettingsareconfiguredtodoso.
Example
Toimmediatelyresetthesystem,typethefollowingcommandatthebootprompt:
boot> reset
Enterasys Networks RBTBootstrap 1.17 Release
Testing Low Memory 1 ............
Testing Low Memory 2 ............
CISTPL_VERS_1: 4.1 <SanDisk> <SDP> <5/3 0.6>
Reset Cause (0x02) is COLD
Enterasys Networks RBT Bootstrap/Bootloader
Version 1.6.5 Release
Bootstrap 0 version: 1.17 Active
Bootloader 0 version: 1.6.5 Active
Bootstrap 1 version: 1.17
Bootloader 1 version: 1.6.3
RBT Board Revision: 3.
RBT Controller Revision: 24.
POE Board Revision: 1
POE Controller Revision: 6
BOOT Index: 0
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;boot=0
Related Commands
bootonpage 24‐3