Specifications

RoamAbout Mobility System Software Command Line Reference 24-5
change
Changesparametersinthecurrentlyactivebootprofile.(Forinformationaboutbootprofiles,see
showonpage 24‐16.)
Syntax
change
Parameters
None.
Defaults
Thedefaultboottypeisc(compactflash).Thedefaultfilenameisdefault.Thedefaultflagssetting
is0x00000000(allflagsdisabled)andthedefaultoptions listisrun=nos;boot=0.Thedefaultdevice
settingisthebootpartitionspecifiedbythemostrecentsetbootpartitioncommandtypedatthe
Enabled
leveloftheCLI,orboot0ifthecommandhasneverbeentyped.
Mode
Bootprompt.
Usage
Afteryoutypethechangecommand,thesysteminteractivelydisplaysthecurrentsettingofeach
parameterandpromptsyouforthenewsetting.Whenprompted,typethenewsetting,press
Entertoacceptthecurrentsetting,ortype.(period)tochangethesettingtoitsdefaultvalue.To
backup
tothepreviousparameter,type‐(hyphen).
Forinformationabouteachofthebootparametersyoucanset,seeshowonpage 24‐16.
Example
Thefollowingcommandenterstheconfigurationmodeforthecurrentlyactivebootprofile,
changesthedevicetoboot1,andleavestheotherparameterswiththeircurrentsettings:
boot> change
Changing the default configuration is not recommended.
Are you sure that you want to proceed? (y/n)
BOOT TYPE: [c]
DEVICE: [boot0:]boot1
FILENAME: [default]
FLAGS: [0x00000000]
OPTIONS: [run=nos;boot=0]
Related Commands
• bootonpage 24‐3
• createonpage 24‐6
• deleteonpage 24‐7
• dhcponpage 24‐8
• nextonpage 24‐14
• showonpage 24‐16