Specifications

4-8 Port Commands
clear port type
Removesallconfigurationsettingsfromaportandresetstheportasanetwork port.
Syntax
clear port type port-list
Parameters
Defaults
TheclearedportbecomesanetworkportbutisnotplacedinanyVLANs.
Mode
Enabled.
Usage
Usethiscommandtochangeaportbacktoanetworkport.Allconfigurationsettingsspecificto
theporttypeareremoved.Forexample,ifyouclearanAccessPointport,allAP‐specificsettings
areremoved.Table 4‐1liststhedefaultnetworkportsettingsthatMSSapplieswhenyouclear
a
port’s type.
Note: When you clear a port, MSS ends user sessions that are using the port.
port‐list Listofphysicalports.MSSresetsandremovestheconfigurationfromall
thespecifiedports.
Table 4-1 Network Port Defaults
Port Parameter Setting
VLANmembership None.
Note: Although the command changes a port to a network port, the
command does not place the port in any VLAN. To use the port in a
VLAN, you must add the port to the VLAN.
SpanningTreeProtocol(STP) BasedontheVLAN(s)youaddtheportto.
802.1X Noauthorization.
Portgroups None.
InternetGroupManagement
Protocol(IGMP)snooping
EnabledasportisaddedtoVLANs.
AccessPointandradio
parameters
Notapplicable
Maximumusersessions Notapplicable