Specifications

RoamAbout Mobility System Software Command Line Reference 24-1
24
Boot Prompt Commands
Bootpromptcommandsenableyoutoperformbasictasks,includingbootingasystemimagefile,
fromthebootprompt(boot>).ACLIsessionentersthebootpromptifMSSdoesnotboot
successfullyoryouintentionallyinterruptthe bootprocess. Tointerruptthebootprocess,pressq
followedbyEnter(return).
Thischapterpresentsbootpromptcommandsalphabetically.Usethefollowingtabletolocate
commandsinthischapterbasedontheiruse.
Caution: Generally, boot prompt commands are used only for troubleshooting. Enterasys
Networks, Inc. recommends that you use these commands only when working with
Enterasys Networks to diagnose a system issue. In particular, commands that change boot
parameters can interfere with a RoamAbout switch’s ability to boot successfully.
For information about...
Refer to page...
autoboot 24-2
boot 24-3
change 24-5
create 24-6
delete 24-7
dhcp 24-8
diag 24-9
dir 24-10
fver 24-11
help 24-12
ls 24-13
next 24-14
reset 24-15
show 24-16
test 24-18
version 24-19