Specifications

RoamAbout Mobility System Software Command Line Reference 22-7
set snoop mode
Enablesasnoopfilter.AsnoopfilterdoesnottakeeffectuntilyoumapittoanDAPradioand
enablethefilter.
Syntax
set snoop {filter-name | all} mode {enable [stop-after num-pkts] | disable}
Defaults
Snoopfiltersaredisabledbydefault.
Mode
Enabled.
Usage
Thefiltermodeisnotretainedifyouchangethefilterconfigurationordisableandreenablethe
radio,orwhentheDAPortheRoamAboutSwitchisrestarted.Youmustreenablethefilterto
placeitbackintoeffect.
Example
Thefollowingcommandenablessnoopfiltersnoop1,andconfiguresthefiltertostopafter5000
packetsmatchthefilter:
RBT-8100# set snoop snoop1 mode enable stop-after 5000
success: filter 'snoop1' enabled
Related Commands
• showsnooponpage 22‐8
• showsnoopinfoonpage 22‐9
• showsnoopmaponpage 22‐10
• showsnoopstatsonpage 22‐11
filter‐name|all} Nameofthesnoopfilter.Specifyalltoenableallsnoopfilters.
enable
[stop‐afternum‐pkts]
Enablesthesnoopfilter.
Thestop‐afteroption
disablesthefilterafterthespecified
numberofpacketsmatchthefilter.Withoutthestop‐after
option,thefilteroperatesuntilyoudisableitoruntiltheDAP
isrestarted.
disable Disablesthesnoopfilter.