Specifications

RoamAbout Mobility System Software Command Line Reference 22-1
22
Snoop Commands
Usesnoopcommandstomonitorwirelesstraffic,byusingaDistributedAP(DAP)asasniffing
device.TheDAPcopiesthesniffed802.11packetsandsendsthecopiestoanobserver,whichis
typicallyaprotocolanalyzersuchasEtherealorTethereal.
Formoreinformation,includingsetupinstructionsforthemonitoring
station,refertothe
“RemoteMonitoringTraffic”sectioninthe“TroubleshootingaRoamAboutSwitch”chapterofthe
RoamAboutMobilitySystemSoftwareConfigurationGuide.
Thischapterpresentssnoopcommandsalphabetically.Usethefollowingtabletolocate
commandsinthischapter.
For information about... Refer to page...
clear snoop 22-2
clear snoop map 22-3
set snoop 22-4
set snoop map 22-6
set snoop mode 22-7
show snoop 22-8
show snoop info 22-9
show snoop map 22-10
show snoop stats 22-11