Specifications

RoamAbout Mobility System Software Command Line Reference 21-1
21
Trace Commands
Usetracecommandstoperformdiagnosticroutines.WhileMSSallowsyoutorunmanytypesof
traces,thischapterdescribescommandsforthosetracesyouaremostlikelytouse.Foracomplete
listingofthetypesoftracesMSSallows,typetheset trace ?command.
Thischapterpresentstracecommandsalphabetically.
Usethefollowingtabletolocatecommands
inthischapter.
Caution: Using the set trace command can have adverse effects on system performance.
Enterasys Networks, Inc. recommends that you use the lowest levels possible for initial trace
commands, and slowly increase the levels to get the data you need.
For information about...
Refer to page...
clear log trace 21-2
clear trace 21-3
save trace 21-4
set trace authentication 21-5
set trace authorization 21-6
set trace dot1x 21-7
set trace sm 21-8
show trace 21-9