Specifications

RoamAbout Mobility System Software Command Line Reference 20-23
set boot partition
Specifiesthebootpartitioninwhichtolookforthesystem imagefilefollowingthenextsystem
reset,softwarereload,orpowercycle.
Syntax
set boot partition {boot0 | boot1}
Parameters
Defaults
Bydefault,aRoamAboutswitchusesthesamebootpartitionforthenextsoftwarereloadthatwas
usedtobootthecurrentlyrunningimage.
Mode
Enabled.
Usage
Todeterminethebootpartitionthatwasusedtoloadthecurrentlyrunningsoftwareimage,use
thedircommand.
Example
Thefollowingcommandsetsthebootpartitionforthenextsoftwarereloadtopartition1:
RBT-8100# set boot partition boot1
success: Boot partition set to boot1.
Related Commands
• copyonpage 20‐5
• dironpage 20 ‐8
• resetsystemonpage 20‐16
boot0 Bootpartition0.
boot1 Bootpartition1.