Specifications

RoamAbout Mobility System Software Command Line Reference 20-11
load config
LoadsconfigurationcommandsfromafileandreplacestheRoamAboutswitch’srunning
configurationwiththecommandsintheloadedfile.
Syntax
load config [url]
Parameters
Defaults
Thedefaultfilelocationisnonvolatilestorage.
Ifyoudonotspecifyafilename,MSSusesthesameconfigurationfilenamethatwasusedforthe 
previousconfigurationload.Forexample,iftheRoamAboutswitchusedconfigurationforthe
mostrecentconfigurationload,MSSusesconfigurationagainunlessyouspecifyadifferent

filename.TodisplaythefilenameoftheconfigurationfileMSSloadedduringthelastreboot,use
theshowbootcommand.
Mode
Enabled.
Usage
Thiscommandcompletelyreplacestherunningconfigurationwiththeconfigurationinthefile.
Examples
Thefollowingcommandreloadstheconfigurationfromthemostrecentlyloadedconfiguration
file:
RBT-8100# load config
Reloading configuration may result in lost of connectivity, do you wish to
continue? (y/n) [n]y
success: Configuration reloaded
Caution: This command completely removes the running configuration and replaces it with the
configuration contained in the file. Enterasys Networks recommends that you save a copy of the
current running configuration to a backup configuration file before loading a new configuration.
url Filename.Specifybetween1and128alphanumericcharacters,withno
spaces.
Ifthefileisinasubdirectory,specifythesubdirectoryname,followedbya
forwardslash,infrontofthefilename.Forexample:backup_configs/
config_c.
Note: The current version supports loading a configuration file only from the switch’s nonvolatile
storage. You cannot load a configuration file directly from a TFTP server.