Specifications

19-32 RF Detection Commands
show rfdetect visible
DisplaystheBSSIDsdiscoveredbyaspecificEnterasys Networksradio.ThedataincludesBSSIDs
transmittedbyotherEnterasys Networksradiosaswellasbythird‐partyaccesspoints.
Syntax
show rfdetect visible mac-addr
show rfdetect visible dap dap-num [radio {1 | 2}]
Parameters
Defaults
None.
Mode
Enabled.
Usage
IfanEnterasys NetworksradioissupportingmorethanoneSSID,eachofthecorresponding
BSSIDsislistedseparately.
TodisplayrogueinformationfortheentireMobilityDomain,usetheshowrfdetectmobility‐
domaincommandontheseedswitch.
Example
Tofollowingcommanddisplaysinformationabouttheroguesdetectedbyradio1onaccesspoint
port3:
RBT-8100# show rfdetect visible ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC Vendor Type Ch RSSI Flags SSID
----------------- ------- ----- --- ---- ------ --------------------------------
00:07:50:d5:cc:91 Cisco intfr 6 -60 i----w r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 6 -82 i----w r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 2 -54 i-----
00:0a:5e:4b:4a:c0 3Com intfr 11 -57 i----- public
00:0a:5e:4b:4a:c2 3Com intfr 11 -86 i-t1-- enterasyswlan
mac‐addr BaseMACaddressoftheEnterasys Networksradio.
Note: To display the base MAC address of an Enterasys Networks radio, use the
show {ap | dap} status command.
dap‐num NumberofaDistributedaccesspointforwhichtodisplayneighboring
BSSIDs.
radio1 Showsneighborinformationforradio1.
radio2 Showsneighborinformationforradio2.(Thisoptiondoesnotapplyto
single‐radiomodels.)