Specifications
RoamAbout Mobility System Software Command Line Reference 3-27
Related Commands
• clearsystemonpage 3‐5
• setsystemcontactonpage 3 ‐15
• setsystemcountrycodeonpage 3‐16
• setsystemip‐addressonpage 3 ‐20
• setsystemlocationonpage 3‐21
• setsystemnameonpage 3‐22
System Contact Contact information about the system administrator or another person to contact
about the system (optionally configured with set system contact).
System IP Common interface, source, and default IP address for the RAS, in dotted decimal
notation (configured with set system ip-address).
System idle timeout Number of seconds MSS allows a CLI management session (console, Telnet, or
SSH) to remain idle before terminating the session. (The system idle timeout can be
configured using the set system idle-timeout command.)
System MAC RAS media access control (MAC) machine address set at the factory, in
6-byte hexadecimal format.
Boot Time Date and time of the last system reboot.
Uptime Number of days, hours, minutes, and seconds that the RAS has been operating
since its last restart.
Fan status Operating status of the RAS cooling fans:
• OK—Fan is operating.
• Failed—Fan is not operating. MSS sends an alert to the system log every
5 minutes until this condition is corrected.
Temperature Status of temperature sensors at three locations in the RAS:
• ok—Temperature is within the acceptable range of 0° C to 50° C (32° F to
122° F).
• Alarm—Temperature is above or below the acceptable range. MSS sends an
alert to the system log every 5 minutes until this condition is corrected.
PSU Status Status of the lower and upper power supply units:
• missing—Power supply is not installed or is inoperable.
• DC ok—Power supply is producing DC power.
• DC output failure—Power supply is not producing DC power. MSS sends an alert
to the system log every 5 minutes until this condition is corrected.
• AC ok—Power supply is receiving AC power.
• AC not present—Power supply is not receiving AC power.
Memory Current size (in megabytes) of nonvolatile memory (NVRAM) and synchronous
dynamic RAM (SDRAM), plus the percentage of total memory space in use, in the
following format:
NVRAM size /SDRAM size (percent of total)
Table 3-2 show system Output (continued)
Field Description