Specifications

RoamAbout Mobility System Software Command Line Reference 19-13
set rfdetect signature
Enablesaccesspointsignatures.Anaccesspointsignatureisasetofbitsinamanagementframe 
sentbyanaccesspointthatidentifiesthataccesspointtoMSS.Ifsomeoneattemptstospoof
managementpacketsfromanEnterasys Networksaccesspoint,MS Scandetectthespoofattempt.
Syntax
set rfdetect signature {enable | disable}
Parameters
Defaults
accesspointsignaturesaredisabledbydefault.
Mode
Enabled.
Usage
ThecommandappliesonlytoaccesspointsmanagedbytheRoamAboutswitchonwhichyou
enterthecommand.ToenablesignaturesonallaccesspointsinaMobilityDomain,enterthe
commandoneachRoamAboutswitchintheMobilityDomain.
Example
ThefollowingcommandenablesaccesspointsignaturesonaRoamAboutswitch:
RBT-8100# set rfdetect signature enable
success: signature is now enabled.
enable Enablesaccesspointsignatures.
disable Disablesaccesspointsignatures.
Note: You must use the same access point signature setting (enabled or disabled) on all
RoamAbout switches in a MobilityDomain.