Specifications

RoamAbout Mobility System Software Command Line Reference 16-11
set radius client system-ip
CausesallRADIUSrequeststobesourcedfromtheIPaddressspecifiedbythesetsystemip‐
addresscommand,providingapermanentsourceIPaddressforRADIUSpacketssentfromthe
RoamAboutswitch.
Syntax
set radius client system-ip
Defaults
None.
Ifyoudonotusethiscommand,RADIUSpacketsleavingtheRoamAboutswitchhavethesource
IPaddressoftheoutboundinterface,whichcanchangeasroutingconditionschange.
Mode
Enabled.
Usage
TheRoamAboutswitchsystemIPaddressmustbesetbeforeyouusethiscommand.
Example
ThefollowingcommandsetstheRoamAboutswitchsystemIPaddressastheaddressofthe
RADIUSclient:
RBT-8100# set radius client system-ip
success: change accepted.
Related Commands
• clearradiusclientsystem‐iponpage 16‐4
• setsystemip‐addressonpage 3 ‐20