Specifications

RoamAbout Mobility System Software Command Line Reference 13-13
set igmp receiver
AddsorremovesanetworkportinthelistofportsonwhichaRoamAboutswitchforwardstraffic
tomulticastreceivers.Staticmulticastreceiverportsareimmediatelyaddedtoorremovedfrom
thelistofreceiverportsanddonotageout.
Syntax
set igmp receiver port port-list {enable | disable}
Parameters
Defaults
Bydefault,noportsarestaticmulticastreceiverports.
Mode
Enabled.
Usage
YoucannotaddAPaccessportsorwiredauthenticationportsasstaticmulticastports.However,
MSScandynamicallyaddtheseporttypestothelistofmulticastportsbasedonmulticasttraffic.
Example
Thefollowingcommandaddsport7asastaticmulticastreceiverport:
RBT-8100# set igmp receiver port 7 enable
success: change accepted.
Thefollowingcommandremovesport7fromthelistofstaticmulticastreceiverports:
RBT-8100# set igmp receiver port 7 disable
success: change accepted.
Related Commands
showigmpreceiver‐tableonpage 13‐23
portport‐list Networkportlist.MSSaddsthespecifiedportstothelistofstaticmulticast
receiverports.
enable Addstheporttothelistofstaticmulticastreceiverports.
disable Removestheportfromthelistofstaticmulticastreceiverports.