Specifications

RoamAbout Mobility System Software Command Line Reference 13-11
set igmp qri
ChangestheIGMPqueryresponseintervaltimerononeVLANorallVLANsonaRoamAbout
switch.
Syntax
set igmp qri tenth-seconds [vlan vlan-id]
Parameters
Defaults
Thedefaultqueryresponseintervalis100tenthsofasecond(10 seconds).
Mode
Enabled.
Usage
ThequeryresponseintervalisapplicableonlywhentheRoamAboutswitchisquerierforthe
subnet.Fortheswitchtobecomethequerier,thepseudo‐querierfeaturemustbeenabledonthe
switchandtheswitchmusthavethelowestIPaddressamongallthedeviceseligibletobecomea
querier.
Toenablethepseudo‐querierfeature,usesetigmpquerier.
Example
ThefollowingcommandchangesthequeryresponseintervalonVLANorangeto50tenthsofa
second(5seconds):
RBT-8100# set igmp qri 50 vlan orange
success: change accepted.
Related Commands
• setigmplmqionpage 13‐4
• setigmpoqionpage 13‐8
• setigmpqionpage 13‐10
• setigmpquerieronpage 13‐12
• setigmprvonpage 13‐14
qritenth‐seconds Amountoftime(intenthsofasecond)thattheRoamAboutswitchwaits
forareceivertorespond
toagroup‐specificquerymessagebefore
removingthereceiverfromthereceiverlistforthegroup.Youcan
specifyavaluefrom1 through65,535.
vlanvlan‐id VLANnameornumber.IfyoudonotspecifyaVLAN, thetimerchange
appliestoallVLANs.