Specifications

13-10 IGMP Snooping Commands
set igmp qi
ChangestheIGMPqueryintervaltimerononeVLANorallVLANsonaRoamAboutswitch.
Syntax
set igmp qi seconds [vlan vlan-id]
Parameters
Defaults
Thedefaultqueryintervalis125seconds.
Mode
Enabled.
Usage
ThequeryintervalisapplicableonlywhentheRoamAboutswitchisquerier forthesubnet.For
theswitchtobecomethequerier,thepseudo‐querierfeaturemustbeenabledontheswitchand
theswitchmusthavethelowestIPaddressamongallthedeviceseligibletobecomeaquerier.To

enablethepseudo‐querierfeature,usethesetigmpqueriercommand.
Example
ThefollowingcommandchangesthequeryintervalonVLANorangeto100seconds:
RBT-8100# set igmp qi 100 vlan orange
success: change accepted.
Related Commands
• setigmplmqionpage 13‐4
• setigmpoqionpage 13‐8
• setigmpqrionpage 13‐11
• setigmpquerieronpage 13‐12
• setigmpmrouteronpage 13‐5
• setigmprvonpage 13‐14
qiseconds Numberofsecondsthatelapsebetweengeneralqueriessentbythe
RoamAboutswitch
whentheswitchisthequerierforthesubnet.Youcan
specifyavaluefrom1through65,535.
vlanvlan‐id VLANnameornumber.Ifyoudonotspeci fyaVLAN,thetimerchange
appliestoallVLANs.