Specifications

13-8 IGMP Snooping Commands
set igmp oqi
ChangestheIGMPother‐querier‐presentintervaltimerononeVLANorallVLANsona
RoamAboutswitch.
Syntax
set igmp oqi seconds [vlan vlan-id]
Parameters
Defaults
Thedefaultother‐querier‐presentintervalis255 seconds (4.25 minutes).
Mode
Enabled.
Usage
ARoamAboutswitchcannotbecomethequerierunlessthepseudo‐querierfeatureisenabledon
theswitch.Whenthefeatureisenabled,theswitchbecomesthequerierforasubnetsolongasthe
switchdoesnotreceiveaquerymessagefromarouterwithalowerIPaddressthanthe
IPaddress
oftheswitchinthatsubnet.Toenablethepseudo‐querierfeature,usesetigmpquerier.
Example
Thefollowingcommandchangestheother‐querier‐presentintervalonVLANorangeto200
seconds:
RBT-8100# set igmp oqi 200 vlan orange
success: change accepted.
Related Commands
• setigmplmqionpage 13‐4
• setigmpqionpage 13‐10
• setigmpqrionpage 13‐11
• setigmpquerieronpage 13‐12
• setigmpmrouteronpage 13‐5
• setigmprvonpage 13‐14
oqiseconds NumberofsecondsthattheRoamAboutswitchwaitsforageneralqueryto
arrivebeforeelectingitselfthequerier.Youcanspecifyavaluefrom1
through65,535.
vlanvlan‐id VLANnameornumber.Ifyoudonotspeci fyaVLAN,thetimerchange
appliestoallVLANs.