Specifications

13-4 IGMP Snooping Commands
set igmp lmqi
ChangestheIGMPlastmemberqueryintervaltimerononeVLANorallVLANsonaRoamAbout
switch.
Syntax
set igmp lmqi tenth-seconds [vlan vlan-id]
Parameters
Defaults
Thedefaultlastmemberqueryintervalis10tent hsofasecond(1 second).
Mode
Enabled.
Example
ThefollowingcommandchangesthelastmemberqueryintervalonVLANorangeto5tenthsofa
second:
RBT-8100# set igmp lmqi 5 vlan orange
success: change accepted.
Related Commands
• setigmpoqionpage 13‐8
• setigmpqionpage 13‐10
• setigmpmrouteronpage 13‐5
lmqitenth‐seconds Amountoftime(intenthsofasecond)thattheRoamAboutswitch
waitsforaresponsetoagroup‐specificqueryafterreceivingaleave
messageforthatgroup,before
removingthereceiverthat sentthe
leavemessagefromthelistofreceiversforthegroup.Ifthereareno
morereceiversforthegroup,thesw itchalsosendsaleavemessagefor
thegrouptomulticastrouters.Youcanspecifyavaluefrom1 through
65,535.
vlanvlan‐id VLANname
ornumber.IfyoudonotspecifyaVLAN,thetimer
changeappliestoallVLANs.