Specifications

RoamAbout Mobility System Software Command Line Reference 12-15
set spantree portpri
ChangestheSTPpriorityofanetworkportorportsforselectionaspart ofthe pathtotheSTProot
bridgeinthedefaultVLANonaRoamAboutswitch.
Syntax
set spantree portpri port-list priority value
Parameters
Defaults
ThedefaultSTPpriorityforallnetworkportsis128.
Mode
Enabled.
Usage
ThiscommandappliesonlytothedefaultVLAN(VLAN 1).Tochangethepriorityofaportin
anotherVLAN,usethesetspantreeportvlanpricommand.
Example
Thefollowingcommandsetsthepriorityofports3and4to48:
RBT-8100# set spantree portpri 3-4 priority 48
success: change accepted.
Related Commands
• clearspantreeportprionpage 12‐3
• clearspantreeportvlanprionpage 12‐5
• setspantreeportvlanprionpage 12‐17
• showspantreeonpage 12‐20
port‐list Listofports.MSSchangesthepriorityonthespecifiedports.
priorityvalue Priorityvalue.Youcanspecifyavaluefrom0(highestpriority)through255
(lowest
priority).