Specifications

12-10 STP Commands
set spantree hello
ChangestheintervalbetweenSTPhellomessagessentbyaRoamAboutswitchwhenoperatingas
therootbridge,ononeorallofitsconfiguredVLANs.
Syntax
set spantree hello interval {all | vlan vlan-id}
Parameters
Defaults
Thedefaulthellotimerintervalis2seconds.
Mode
Enabled.
Example
ThefollowingcommandchangesthehellointervalforallVLANsto4seconds:
RBT-8100# set spantree hello 4 all
success: change accepted.
Related Commands
showspantreeonpage 12‐20
interval Intervalvalue.Youcanspecifyfrom1through10seconds.
all ChangestheintervalonallVLANs.
vlanvlan‐id VLANnameornumber.MSSchangestheintervalononlythespecified
VLAN.