Specifications

11-158 Access Point Commands
Max Rx Lifetime Number of milliseconds that a frame scheduled to be transmitted by a radio
in the radio profile can remain in buffer memory.
RTS Threshold Minimum length (in bytes) a frame can be for a radio in the radio profile to
use the RTS/CTS method to send the frame. The RTS/CTS method clears
the air of other traffic to avoid corruption of the frame due to a collision with
another frame.
Frag Threshold Maximum length (in bytes) a frame is allowed to be without being fragmented
into multiple frames before transmission by a radio in the radio profile.
Long Preamble Indicates whether an 802.11b radio that uses this radio profile advertises
support for frames with long preambles only:
• YES—Advertises support for long preambles only.
• NO—Advertises support for long and short preambles.
Tune Channel Indicates whether RF Auto-Tuning is enabled for dynamically setting and
tuning channels.
Tune Power Indicates whether RF Auto-Tuning is enabled for dynamically setting and
tuning power levels.
Tune Channel Interval Interval, in seconds, at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous interval,
and changes radio channels if needed.
Tune Power Interval Interval, in seconds, at which RF Auto-Tuning decides whether to change the
power level on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous interval,
and changes radio power levels if needed.
Client Backoff Timer Interval, in minutes, at which radios in a radio profile reduce power after
temporarily increasing the power to maintain the minimum data rate for an
associated client. At the end of each power-backoff interval, radios that
temporarily increased their power reduce it by 1 dBm. The power backoff
continues in 1 dBm increments after each interval until the power returns to
expected setting.
Channel Holddown Minimum number of seconds a radio in a radio profile must remain at its
current channel assignment before RF Auto-Tuning can change the channel.
Countermeasures Indicates whether countermeasures are enabled.
Active-Scan Indicates whether the active-scan mode of RF detection is enabled.
QoS Mode Indicates the Quality-of-Service setting for AP radio forwarding queues:
• wmm—AP forwarding queues provide standard priority handling for WMM
devices.
• svp—SP forwarding queues are optimized for SpectraLink Voice Priority
(SVP).
For information about the QoS modes, see the “Configuring Quality of
Service” chapter in the RoamAbout Mobility System Software Configuration
Guide.
Table 11-19 Output for show radio-profile (continued)
Output What it displays...