Specifications

RoamAbout Mobility System Software Command Line Reference 11-151
show dap connection
DisplaysthesystemIPaddressoftheRoamAboutswitchthatbootedaDistributedAP.
Syntax
show dap connection [dap-num | serial-id serial-ID]
Parameters
Defaults
None.
Mode
Enabled.
Usage
Theserial‐idparameterdisplaystheactiveconnectionforthespecifiedDistributedaccesspoint
evenifthataccesspointisnotconfiguredonthisRoamAboutswitch.Ifyouinsteadusethe
commandwiththedap‐numparameterorwithoutaparameter,connectioninformationis
displayedonlyforDistributedaccesspointsthat
areconfiguredonthisRoamAboutswitch.
ThiscommandprovidesinformationonlyiftheDistributedAPisconfiguredontheswitchwhere
youusethecommand.Theswitchdoesnotneed tobetheonethtbootedtheAP,butitmusthave
theAPinitsconfiguration.Also,theswitchthat
bootedtheAPmustbeinthesameMobility
Domainastheswitchwhereyouusethecommand.
IfaDistributedAPisconfiguredonthisRoamAboutSwitch(oranotherRoamAbou tswitchinthe
sameMobilityDomain)butdoesnothaveanactiveconnection,thecommanddoesnotdisplay
informationfor
theAP.ToshowconnectioninformationforDistributedAPs,usetheshowdap
globalcommandononeoftheswitcheswheretheAPsareconfigured.
Examples
ThefollowingcommanddisplaysinformationforallDistributedaccesspointsconfiguredonthis
RoamAboutswitchthathaveactiveconnections:
RBT-8100# show dap connection
Total number of entries: 2
DAP Serial Id DAP IP Address RBT IP Address
--- ----------- --------------- ---------------
2 112233 10.10.2.27 10.3.8.111
4 0333000298 10.10.3.34 10.3.8.111
dap‐num NumberofaDistributedaccesspointforwhichtodisplay
informationaboutitsactiveconnection.
serial‐idserial‐ID AccesspointserialID.