Specifications

RoamAbout Mobility System Software Command Line Reference 11-145
show auto-tune attributes
DisplaysthecurrentvaluesoftheRFatt ributesRF Auto‐Tuningusestodecidewhethertochange
channelorpowersettings.
Syntax
show auto-tune attributes [ap AP-num [radio {1 | 2| all}]]
show auto-tune attributes [dap dap-num [radio {1 | 2| all}]]
Parameters
Defaults
None.
Mode
Enabled.
Example
ThefollowingcommanddisplaysRFattributeinformationforradio 1onthedirectlyconnected
accesspointonport2:
RBT-8100# show auto-tune attributes ap 2 radio 1
Auto-tune attributes for port 2 radio 1:
Noise: -92 Packet Retransmission Count: 0
Utilization: 0 Phy Errors Count: 0
CRC Errors count: 122
Table 11‐13describesthefieldsinthisdisplay.
ap‐num APportconnectedtotheaccesspointforwhichtodisplayRFattributes.
dap‐num NumberofaDistributedaccesspointforwhichtodisplayRFattributes.
radio1 ShowsRFattributeinformationforradio1.
radio2 ShowsRFattributeinformationforradio
2.(Thisoptiondoesnotapplyto
single‐radiomodels.)
radioall ShowsRFattributeinformationforbothradios.
Table 11-13 Output for show auto-tune attributes
Output What it displays...
Noise Noise threshold on the active channel. RF Auto-Tuning prefers channels with
low noise levels over channels with higher noise levels.
Utilization Number of multicast packets per second that a radio can send on a channel
while continuously sending fixed size frames over a period of time. The
number of packets that are successfully transmitted indicates how busy the
channel is.