Specifications

11-144 Access Point Commands
RFID Reports Status of AeroScout asset tag support.
• Active—The AeroScout Engine has enabled the tag report mode on the
AP.
• Inactive—The AeroScout Engine has not enabled, or has disabled, the
tag report mode on the AP.
This field is displayed only if the rfid-mode option is enabled on the radio
profile that manages the radio.
Table 11-12 Output for show ap status terse and show dap status terse
Output What it displays...
Port RoamAbout port number connected to the access point.
Flg Operational status flags for the access point.
For flag definitions, see the key in the command output.
IP Address IP address of the access point. The address is assigned to the access point
by a DHCP server.
Note: This field is applicable only if the access point is configured on the
RoamAbout switch as a Distributed access point.
Model Access point model number.
MAC Address MAC address of the access point.
Radio1 State, channel, and power information for radio 1:
• The state can be D (disabled) or E (enabled).
• The channel and power settings are shown as channel/power.
Radio2 State, channel, and power information for radio 2.
Uptime Amount of time since the access point booted using this link.
Table 11-11 Output for show ap status (continued)
Output What it displays...