Specifications

RoamAbout Mobility System Software Command Line Reference 11-143
Radio 1 type
Radio 2 type
802.11 type and configuration state of the radio.
• The configure succeed state indicates that the access point has received
configuration parameters for the radio and the radio is ready to accept
client connections.
• 802.11b protect indicates that the 802.11b/g radio is sending messages to
802.11b devices, while sending 802.11g traffic at higher data rates, to
inform the 802.11b devices about the 802.11g traffic and reserve
bandwidth for the traffic. Protection mode remains in effect until 60
seconds after the last 802.11b traffic is detected by the 802.11b/g radio
.
• Sweep Mode indicates that a disabled radio is nonetheless participating in
rogue detection scans. Even though this message appears only for
disabled radios, all radios, enabled or disabled, participate in rogue
detection.
• Countermeasures Enabled indicates that the radio is sending
countermeasures packets to combat a rogue.
• Radar Scan indicates that the radio is performing the initial channel
availability check for Dynamic Frequency Selection (DFS). This state lasts
during the first 60 seconds an 802.11a radio is on a new channel, during
which time the radio does not transmit. If the radio does not detect any
radar on the channel, the radio starts using the channel for data. If the
radio does detect radar, the flag changes to Radar Detected. (See below).
• Radar Detected indicates that DFS has detected radar on the channel.
When this occurs, the AP stops transmitting on the channel for 30
minutes. If RF Auto-Tuning is enabled for channel assignment, the radio
selects another channel and performs the initial channel availability check
on the new channel, during which time the flag changes back to Radar
Scan.
• The following information appears for external antennas:
• External antenna detected, configured as antenna-model—Indicates
that an external antenna has been detected, and lists the antenna
model configured on the radio. (MSS does not detect the specific
model.)
• External antenna detected, not configured—Indicates that an external
antenna was detected but no external antenna is configured on the
radio.
• External antenna not detected, configured as antenna-model—
Indicates that an external antenna is configured on the radio but no
external antenna was detected.
operational channel The channel on which the radio is currently operating.
Note: If the channel number is followed by (Auto), the value was set
by RF Auto-Tuning.
operational power The power level at which the radio is currently operating.
Note: If the power setting is followed by (Auto), the value was set by
RF Auto-Tuning.
base mac Base MAC address of the radio.
bssid, ssid SSIDs configured on the radio and their BSSIDs.
Table 11-11 Output for show ap status (continued)
Output What it displays...