Specifications

RoamAbout Mobility System Software Command Line Reference 11-139
show {ap | dap} group
Displaysconfigurationinformationandload‐balancingstatusforaccesspointgroups.
Syntax
show {ap | dap} group [name]
Parameters
Defaults
None.
Mode
Enabled.
Example
Thefollowingcommanddisplaysinformationforaccesspointgrouploadbalance1:
RBT-8100# show ap group loadbalance1
Load Balance Grp Port Clients Status Refused
---------------- ---- ------- --------- -------
loadbalance1 1 1 Accepting 0
loadbalance1 7 6 Refusing 2
Table 11‐10describesthefieldsinthisdisplay.
Related Commands
• set{ap|dap}grouponpage 11‐28
• show{ap|dap}configonpage 11‐128
name NameofanaccesspointgrouporDistributedaccesspointgroup.
Table 11-10 Output for show ap group
Output What it displays...
Load Balance Grp Name of the access point group.
Port RoamAbout switch port number.
Clients Number of active client sessions on the access point.
Status Association status of the access point:
• Accepting—The access point is accepting new associations.
• Refusing—The access point is refusing new associations.
Refused Number of association requests refused by the access point due to load
balancing. MSS resets this counter to 0 when the RoamAbout switch is
restarted, MSS is reloaded, or the access point is removed from the group.