Specifications

11-130 Access Point Commands
Related Commands
• setdaponpage 4‐15
• set{ap|dap}biasonpage 11‐18
• setdapfingerprintonpage 11‐26
• set{ap|dap}grouponpage 11‐28
fingerprint Hexadecimal fingerprint of the access point’s public encryption key.
Note: This field is displayed only for Distributed access points. If the field is
blank, the key has not been verified yet by an administrator. (See set dap
fingerprint on page 11-26.)
boot-download-enable State of the firmware upgrade option:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
force-image-download State of the option to force the AP to download its software image from the
RoamAbout Switch instead of loading the image that is locally stored on the
AP.
load balancing group Names of the access point load-balancing groups to which the access point
belongs. If the value is None, the access point does not belong to any load
balancing groups.
Note: This field is displayed only if the access point is a member of a group.
Radio Radio number. The information listed below this field applies specifically to
the radio.
type Radio type:
•802.11a
•802.11b
•802.11g
mode Radio state:
• Enabled
•Disabled
channel Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile Radio profile that manages the radio. Until you assign the radio to a radio
profile, MSS assigns the radio to the default radio profile.
auto-tune max-power Maximum power level the RF Auto-Tuning feature can set on the radio.
• The value default means RF Auto-Tuning can set the power up to the
maximum level allowed for the country of operation.
• A specific numeric value means you or another administrator set the
maximum value.
Table 11-6 Output for show ap config (continued)
Output What it displays...