Specifications

RoamAbout Mobility System Software Command Line Reference 11-129
Thefollowingexampleshowsconfigu rationinformationforaDistributedaccesspointconfigured
onconnection1:
RBT-8100# show dap config 1
Dap 1: serial-id: 12345678, AP model: RBT-1602, bias: high, name: DAP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
force-image-download: NO
load balancing group: none
location: The conference room
contact: Bob the IT guy
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default
Table 11‐6describesthefieldsinthisdisplay.
Table 11-6 Output for show ap config
Output What it displays...
force-image-download State of the option to force the AP to to download its software image from the
RoamAbout Switch instead of loading the image that is locally stored on the
AP.”.
Port RoamAbout switch port number.
Note: This field is applicable only if the AP is directly connected to the
RoamAbout switch and the RoamAbout switch’s port is configured as an AP
access port.
DAP Connection ID for the Distributed access point.
Note: This field is applicable only if the access point is configured on the
RoamAbout switch as a Distributed access point.
serial-id Serial ID of the access point.
Note: This field is displayed only for Distributed access points.
AP model Access point model number.
POE PoE state on the RoamAbout switch port:
• Enable
•Disable
bias Bias of the RoamAbout switch connection to the access point:
•High
•Low
name Access point name.