Specifications

RoamAbout Mobility System Software Command Line Reference 11-127
set service-profile wpa-ie
EnablestheWPAinformationelement(IE)inwirelessframes.TheWPA IEadvertisestheWPA
authenticationmethodsandciphersuitessupportedbyradiosintheradioprofilemappedtothe
serviceprofile.
Syntax
set service-profile name wpa-ie {enable | disable}
Parameters
Defaults
TheWPAIEisdisabledbydefault.
Mode
Enabled.
Usage
WhentheWPAIEisenabled,thedefaultauthenticationmethodis802.1X.Thereisnodefault
ciphersuite.Youmustenabletheciphersuitesyouwanttheradiostosupport.
Example
ThefollowingcommandenablestheWPAIEinserviceprofilesp2:
RBT-8100# set service-profile sp2 wpa-ie enable
success: change accepted.
Related Commands
• setservice‐profileauth‐dot1xonpage 11‐80
• setservice‐profileauth‐pskonpage 11‐84
• setservice‐profilecipher‐ccmponpage 11‐88
• setservice‐profilecipher‐tkiponpage 11‐89
• setservice‐profilecipher‐wep104onpage 11‐90
• setservice‐profilecipher‐wep40onpage 11‐91
• showservice‐
profileonpage 11‐160
name Serviceprofilename.
enable EnablestheWPAIE.
disable DisablestheWPAIE.