Specifications

11-126 Access Point Commands
set service-profile wep key-index
SetsthevalueofoneoffourstaticWired‐EquivalentPrivacy(WEP)keysforstaticWEP
encryption.
Syntax
set service-profile name wep key-index num key value
Parameters
Defaults
Bydefault,nostaticWEPkeysaredefined.
Mode
Enabled.
Usage
MSSautomaticallyenablesstaticWEPwhenyoudefineaWEPkey.MSScontinuestosupport
dynamicWEP.
Example
Thefollowingcommandconfiguresa5‐byteWEPkeyforkeyindex1onserviceprofilesp2to
aabbccddee.
RBT-8100# set service-profile sp2 wep key-index 1 key aabbccddee
success:changeaccepted.
Related Commands
• setservice‐profilewepactive‐multicast‐indexonpage 11‐124
• setservice‐profilewepactive‐unicast‐indexonpage 11‐125
• showservice‐profileonpage 11‐160
name Serviceprofilename.
key‐indexnum WEPkeyindex.Youcanenteravaluefrom1through4.
keyvalue Hexadecimalvalueofthekey.You
canentera10‐characterASCIIstring
representinga5‐bytehexadecimalnumberora26‐characterASCIIstring
representinga13‐bytehexadecimalnumber.Youcanusenumbersor
letters.ASCIIcharactersinthefollowingrangesaresupported:
•0to9
•AtoF
•atof