Specifications

11-124 Access Point Commands
set service-profile wep active-multicast-index
SpecifiesthestaticWired‐EquivalentPrivacy(WEP)key(oneoffour)touseforencrypting
multicastframes.
Syntax
set service-profile name wep active-multicast-index num
Parameters
Defaults
IfWEPencryptionisenabledandWEPkeysaredefined,accesspointradiosuseWEPkey1to
encryptmulticastframes,bydefault.
Mode
Enabled.
Usage
Beforeusingthiscommand,youmustconfigurevaluesfortheWEPkeysyouplantouse.Usethe
setservice‐profilewepkey‐indexcommand.
Example
Thefollowingcommandconfiguresserviceprofilesp2touseWEPkey2forencryptingmulticast 
traffic:
RBT-8100# set service-profile sp2 wep active-multicast-index 2
success: change accepted.
Related Commands
• setservice‐profilewepactive‐unicast‐indexonpage 11‐125
• setservice‐profilewepkey‐indexonpage 11‐126
• showservice‐profileonpage 11‐160
name Serviceprofilename.
num WEPkeynumber.Youcanentera valuefrom1through4.