Specifications

RoamAbout Mobility System Software Command Line Reference 11-119
set service-profile user-idle-timeout
ChangesthenumberofsecondsMSSwillleaveasessionupforaclientthatisnotsendingdata
andisnotrespondingtokeepalives(idle‐clientprobes).Iftheti merexpires,theclient’ssessionis
changedtotheDissociatedstate.
Thetimerisresetto0eachtimeaclient
sendsdataorrespondstoanidle‐clientprobe.Iftheidle‐
clientprobeisdisabled,thetimerisreseteachtimetheclientsendsdata.
Syntax
set service-profile name user-idle-timeout seconds
Parameters
Defaults
Thedefaultuseridletimeoutis180seconds(3minutes).
Mode
Enabled.
Example
Thefollowingcommandincreasestheuseridletimeoutto360seconds(6minutes):
RBT-8100# set service-profile sp1 user-idle-timeout 360
success: change accepted.
Related Commands
• setservice‐profileidle‐client‐probingonpage 11‐94
• setservice‐profileweb‐portal‐session‐timeoutonpage 11‐123
• showservice‐profileonpage 11‐160
name Serviceprofilename.
seconds Numberofsecondsaclient isallowedtoremainidlebefore
MSSchangesthesessiontotheDissociatedstate.Youcan
specify
from20to86400seconds. 
Todisablethetimer,specify0.