Specifications

11-116 Access Point Commands
set service-profile tkip-mc-time
Changesthelengthoftimethataccesspointradiosusecountermeasuresiftwomessageintegrity
code(MIC)failuresoccurwithin60seconds.Whencountermeasuresareineffect,accesspoint
radiosdissociateallTKIPandWPAWEPclientsandrefuseallassociationandreassociation
requestsuntilthecountermeasuresend.
Syntax
set service-profile name tkip-mc-time wait-time
Parameters
Defaults
Thedefaultcountermeasureswaittimeis60,000ms(60seconds).
Mode
Enabled.
Usage
CountermeasuresapplyonlytoTKIPandWEPclients.ThisincludesWPAWEPclientsandnon‐
WPAWEPclients.CCMPclientsarenotaffected.
TheTKIPciphersuitemustbeenabled.TheWPA IEalsomustbeenabled.
Example
Thefollowingcommandchangesthecountermeasureswaittimeforserviceprofilesp3to
30,000 ms(30 seconds):
RBT-8100# set service-profile sp3 tkip-mc-time 30000
success: change accepted.
Related Commands
• setservice‐profilecipher‐tkiponpage 11‐89
• setservice‐profilewpa‐ieonpage 11 ‐127
• showservice‐profileonpage 11‐160
name Serviceprofilename.
wait‐time Nu mberofmi lliseconds(ms)countermeasuresremainineffect.Youcan
specifyfrom0to60,000.