Specifications

RoamAbout Mobility System Software Command Line Reference 11-115
set service-profile static-cos
EnablesordisablesstaticCoSonaserviceprofile.StaticCoS assignsthesameCoSleveltoall
trafficontheserviceprofile’sSSID,regardlessof802.1porDSCPmarkingsinthepackets
themselves,andregardlessofanyACLsthatmarkCoS.Thisoptionprovidesasimplewayto
configurean
SSIDforprioritytrafficsuchasVoIPtraffic.
WhenstaticCoSisenabled,thestandardMSSprioritizationmechanismisnotused.Instead,the
APsetsCoSasfollows:
•FortrafficfromtheAPtoclients,theAPplacesthetrafficintotheforwardingqueuethat
correspondstotheCoSlevelconfigured
ontheserviceprofile.Forexample,ifthestaticCoS
levelissetto7,theAPradioplacesclienttrafficinitsVoicequeue.
•Fortrafficfromclientstothenetwork,theAPmarkstheDSCPvalueintheIPheadersofthe
tunnelpacketsusedtocarrytheuser
datafromtheAPtotheRoamAboutSwitch.
Syntax
set service-profile name static-cos {enable | disable}
Parameters
Defaults
StaticCoSisdisabledbydefault.
Mode
Enabled.
Usage
TheCoSlevelisspecifiedbythesetservice‐profilecoscommand.
Example
ThefollowingcommandenablesstaticCoSonserviceprofilesp1:
RBT-8100# set service-profile sp1 static-cos enable
success: change accepted.
Related Commands
• setservice‐profilecosonpage 11‐92
• showservice‐profileonpage 11‐160
name Serviceprofilename.
enable EnablesstaticCoSontheserviceprofile.
disable DisablesstaticCoSontheserviceprofile.