Specifications

11-94 Access Point Commands
set service-profile idle-client-probing
DisablesorreenablesperiodickeepalivesfromAPradiostoclientsonaserviceprofile’sSSID.
Whenidle‐clientprobingisenabled,theAPradiosendsaunicastnull‐dataframetoeachclient
every10seconds.Norma lly,aclientthatisstillactive sendsanAckinreplytothekeepalive.
Ifaclientdoesnotsendanydataorrespondtoanykeepalivesbeforetheuseridletimeoutexpires,
MSSchangestheclient’ssessiontotheDisassociatedstate.
Syntax
set service-profile name idle-client-probing {enable | disable}
Parameters
Defaults
Idle‐clientprobingisenabledbydefault.
Mode
Enabled.
Usage
Thelengthoftimeaclientcanremainidle(unresponsivetoidle‐clientprobes)isspecifiedbythe
user‐idle‐timeoutcommand.
Example
Thefollowingcommanddisablesidle‐clientkeepalivesonserviceprofilesp1:
RBT-8100# set service-profile sp1 idle-client-probing disable
success: change accepted.
Related Commands
• setservice‐profileuser‐idle‐timeoutonpage 11‐119
• showservice‐profileonpage 11‐160
name Serviceprofilename.
enable Enableskeepalives.
disable Disableskeepalives.