Specifications

11-92 Access Point Commands
set service-profile cos
SetstheClass‐of‐Service(CoS)levelforstaticCoS.
Syntax
set service-profile name cos level
Parameters
Defaults
ThedefaultstaticCoSlevelis0.
Mode
Enabled.
Usage
ThiscommandappliesonlywhenstaticCoSisenabled.IfstaticCoSisdisabled,prioritization is
basedontheQoSmodeconfiguredintheradioprofile,andonanyACLsthatsetCoS.(Seethe
“ConfiguringQualityofService”chapteroftheRoamAboutMobilitySystemSoftwareConfiguration
Guide.)Toenable
staticCoS,usethesetservice‐profilestatic‐coscommand.
Example
ThefollowingcommandchangesthestaticCoSlevelto7(voicepriority):
RBT-8100# set service-profile sp1 cos 7
success: change accepted.
Related Commands
• setservice‐profilestatic‐cosonpage 11‐115
• showservice‐profileonpage 11‐160
name Serviceprofilename.
level CoSvalueassignedbytheAPtoalltrafficintheserviceprofile.