Specifications

11-88 Access Point Commands
set service-profile cipher-ccmp
EnablesCounterwithCipherBlockChainingMessageAuthenticationCodeProtocol(CCMP)
encryptionwithWPAclients,foraserviceprofile.
Syntax
set service-profile name cipher-ccmp {enable | disable}
Parameters
Defaults
CCMPencryptionisdisabledby default.
Mode
Enabled.
Usage
TouseCCMP,youmustalsoenabletheWPAIE.
Example
Thefollowingcommandconfiguresserviceprofilesp2touseCCMPencryption:
RBT-8100# set service-profile sp2 cipher-ccmp enable
success: change accepted.
Related Commands
• setservice‐profilecipher‐tkiponpage 11‐89
• setservice‐profilecipher‐wep104onpage 11‐90
• setservice‐profilecipher‐wep40onpage 11‐91
• setservice‐profilewpa‐ieonpage 11 ‐127
• showservice‐profileonpage 11‐160
name Serviceprofilename.
enable EnablesCCMP encryptionfor WPAclients.
disable DisablesCCMPencryption
forWPAclients.