Specifications

11-84 Access Point Commands
set service-profile auth-psk
Enablespresharedkey(PSK)authenticationofWi‐FiProtectedAccess(WPA)clientsbyaccess
pointradiosinaradioprofile,whentheWPAinformationelement(IE)isenabledintheservice
profile.
Syntax
set service-profile name auth-psk {enable | disable}
Parameters
Defaults
WhentheWPAIEisenabled,PSKauthenticationofWPAclientsisenabledbydefault.IftheWPA
IEisdisabled,theauth‐psksettinghasnoeffect.
Mode
Enabled.
Usage
ThiscommandaffectsauthenticationofWPAclientsonly.
TousePSKauthentication,youalsomustconfigureapassphraseorkey.Inaddition,youmust
enabletheWPAIE.
Example
ThefollowingcommandenablesPSKauthenticationforserviceprofilewpa_clients:
RBT-8100# set service-profile wpa_clients auth-psk enable
success: change accepted.
Related Commands
• setservice‐profileauth‐dot1xonpage 11‐80
• setservice‐profilepsk‐rawonpage 11‐101
• setservice‐profilewpa‐ieonpage 11 ‐127
• showservice‐profileonpage 11‐160
name Serviceprofilename.
enable EnablesPSKauthenticationof WPAclients.
disable DisablesPSKauthenticationofWPAclients.