Specifications

11-80 Access Point Commands
set service-profile auth-dot1x
Disablesorreenables802.1XauthenticationofWi‐FiProtectedAccess(WPA)clientsbyaccess
pointradios,whentheWPAinformationelement(IE)isenabledintheserviceprofilethatis
mappedtotheradioprofilethattheradiosareusing.
Syntax
set service-profile name auth-dot1x {enable | disable}
Parameters
Defaults
WhentheWPAIEisenabled,802.1XauthenticationofWPAclientsisenabledbydefault.Ifthe
WPAIEisdisabled,theauth‐dot1xsettinghasnoeffect.
Mode
Enabled.
Usage
ThiscommanddoesnotdisabledynamicWEPfornon‐WPAclients.TodisabledynamicWEPfor
non‐WPAclients,enabletheWPAIE(ifnotalreadyenabled)anddisablethe40‐bitWEPand104‐
bitWEPciphersuitesintheWPA IE,iftheyarenotalreadydisabled.
Touse802.1X
authenticationforWPAclients,youalsomustenabletheWPAIE.
Ifyoudisable802.1XauthenticationofWPAclients,theonlymethodavailableforauthenticating
theclientsispresharedkey(PSK)a uthenti cation.Tousethis,youmustenablePSKsupportand
configureapassphraseorkey.
Example
Thefollowingcommanddisables802.1XauthenticationforWPAclientsthatuseserviceprofile
wpa_clients:
RBT-8100# set service-profile wpa_clients auth-dot1x disable
success: change accepted.
name Serviceprofilename.
enable Enables802.1XauthenticationofWPAclients.
disable Disables802.1XauthenticationofWPAclients.