Specifications

RoamAbout Mobility System Software Command Line Reference 11-73
Mode
Enabled.
Usage
Youmustconfiguretheserviceprofilebeforeyoucanmapittoaradioprofile.Youcanmapthe
sameserviceprofiletomorethanoneradioprofile.
Youmustdisableallradiosthatusearadio profilebeforeyoucanchangeparametersinthe
profile.Usethesetradio‐profile
modecommand .
user-idle-timeout 180 Allows a client to remain idle for 180
seconds (3 minutes) before MSS changes
the client’s session to the Disassociated
state.
web-portal-acl portalacl
This is the default only if
the fallthru type on the
service profile has been
set to web-portal.
Otherwise, the value is
unconfigured.
If set to portalacl and the service profile
fallthru is set to web-portal, radios use
the portalacl ACL to filter traffic for Web
Portal users during authentication.
If the fallthru type is web-portal but web-
portal-acl is set to an ACL other than
portalacl, the other ACL is used.
If the fallthru type is not web-portal,
radios do not use the web-portal-acl
setting.
web-portal-form Not configured For WebAAA users, serves the Enterasys
Networks login page.
web-portal-session-
timeout
5 Allows a Web Portal WebAAA session to
remain in the Deassociated state 5
seconds before being terminated
automatically.
wep key-index No keys defined Uses dynamic WEP rather than static
WEP.
Note: If you configure a WEP key for
static WEP, MSS continues to also
support dynamic WEP.
wep active-multicast-index 1 Uses WEP key 1 for static WEP
encryption of multicast traffic if WEP
encryption is enabled and keys are
defined.
wep active-unicast-index 1 Uses WEP key 1 for static WEP
encryption of unicast traffic if WEP
encryption is enabled and keys are
defined.
wpa-ie disable Does not use the WPA IE in transmitted
frames.
Table 11-5 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set To
Default Value