Specifications

RoamAbout Mobility System Software Command Line Reference 11-71
cipher-tkip enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP) to
encrypt traffic sent to WPA clients.
cipher-wep104 disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
cipher-wep40 disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
cos 0 If static CoS is enabled (static-cos is set
to enable), assigns CoS 0 to all data
traffic to or from clients.
dhcp-restrict disable Does not restrict a client’s traffic to only
DHCP traffic while the client is being
authenticated and authorized.
idle-client-probing enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN after
roaming, instead of leaving the roamed
user on the VLAN assigned by the switch
where the user logged on.
Enabling this option does not retain the
user’s initial VLAN assignment in all
cases. (For information, see “set service-
profile keep-initial-vlan” on page 11-95.)
long-retry-count 5 Sends a long unicast frame up to five
times without acknowledgment.
no-broadcast disable Does not reduce wireless broadcast traffic
by sending unicasts to clients for ARP
requests and DHCP Offers and Acks
instead of forwarding them as multicasts.
proxy-arp disable Does not reply on behalf of wireless
clients to ARP requests for client IP
addresses. Instead, the radio forwards the
ARP Requests as wireless broadcasts.
psk-phrase No passphrase defined Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
Table 11-5 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set To
Default Value