Specifications

RoamAbout Mobility System Software Command Line Reference 2-5
set enablepass
Setsthepasswordthatprovidesenabledaccess(forconfigurationandmonitoring)tothe
RoamAboutswitch.
Syntax
set enablepass
Parameters
None.
Defaults
None.
Mode
Enabled.
Usage
Aftertypingthesetenablepasscommand,pressEnter.If youareenteringthefirstenable
passwordonthisR oamAboutswitch,pressEnterattheEnteroldpasswordprompt.Otherwise,
typetheoldpassword.Thentypeapasswordofupto32 alphanumericcharacterswithnospaces,
andreenteritattheRetype
newpasswordprompt.
Example
Thefollowingexamp leillustratesthepromptsthatthesystemdisplayswhentheenablepassword
ischanged.Thepasswordsyouenter arenotdisplayed.
RBT-8100# set enablepass
Enter old password: old-password
Enter new password: new-password
Retype new password: new-password
Password changed
Related Commands
• disableonpage 2‐2
• enableonpage 2‐3
Note: The enable password is case-sensitive.
Caution: Be sure to use a password that you will remember. If you lose the enable password, the
only way to restore it causes the system to return to its default settings and wipes out the
configuration.