Specifications

11-64 Access Point Commands
Mode
Enabled.
Usage
Usethecommandwithoutanyoptionalparameterstocreatenewprofile.Iftheradioprofiledoes
notalreadyexist,MSScreatesanewradioprofile.Usetheenableordisableoptiontoenableor
disablealltheradiosusingaprofile.Toassigntheprofiletooneormoreradios,use
thesetap
radioradio‐profilecommand.
Tochangeaparameterinaradioprofile,youmustfirstdisablealltheradiosintheprofile.After
youcompletethechange,youcanreenabletheradios.
Toenableordisablespecificradioswithoutdisablingallofthem,usethesetapradio
command.
Examples
Thefollowingcommandconfiguresanewradioprofilenamedrp1:
RBT-8100# set radio-profile rp1
success: change accepted.
Thefollowingcommandenablestheradiosthatuseradioprofilerp1:
RBT-8100# set radio-profile rp1 mode enable
Thefollowingcommandsdisabletheradiosthatuseradioprofilerp1,changethebeaconinterval,
thenreenabletheradios:
RBT-8100# set radio-profile rp1 mode disable
RBT-8100# set radio-profile rp1 beacon-interval 200
RBT-8100# set radio-profile rp1 mode enable
ThefollowingcommandenablestheWPAIEonaccesspointradiosinradioprofilerp2:
RBT-8100# set radio-profile rp2 wpa-ie enable
success: change accepted.
qos-mode wmm Classifies and marks traffic based on 802.1p and DSCP, and
optimizes forwarding prioritization of AP radios for Wi-Fi
Multimedia (WMM).
rfid-mode disable Radio does not function as a location receiver in an
AeroScout Visibility System.
rts-threshold 2346 Transmits frames longer than 2346 bytes by means of the
Request-to-Send/Clear-to-Send (RTS/CTS) method.
service-profile No service profiles
defined
You must configure a service profile. The service profile sets
the SSID name and other parameters.
wmm-powersave disable Requires clients to send a separate PSpoll to retrieve each
unicast packet buffered by the AP radio.
Table 11-4 Defaults for Radio Profile Parameters (continued)
Parameter Default Value Radio Behavior When Parameter Set To Default Value