Specifications

11-58 Access Point Commands

set radio-profile dtim-interval

Changesthenumberoftimesaftereverybeaconthateachaccesspointradioinaradioprofile

sendsadeliverytrafficindicationmap(DTIM).Anaccesspointsendsthe multicastandbroadcast

framesstoredinitsbufferstoclientswhorequesttheminresponsetotheDTIM.

Syntax

set radio-profile name dtim-interval interval

Parameters

Defaults

Bydefault,accesspointssendtheDTIMonceaftereachbeacon.

Mode

Enabled.

Usage

Youmustdisableallradiosthatare usingaradioprofilebeforeyoucanchangeparametersinthe

profile.Usethesetradio‐profilemodecommand

TheDTIMintervaldoesnotapplytounicastframes.

Example

ThefollowingcommandchangestheDTIMintervalforradioprofilerp1to2:

RBT-8100# set radio-profile rp1 dtim-interval 2

success: change accepted.

Related Commands

• setradio‐profilemodeonpage 11‐63

• showradio‐profileonpage 11‐157

Note: The DTIM interval applies to both the beaconed SSID and the nonbeaconed SSID.

name Radioprofilename.

interval NumberoftimestheDTIMistransmittedaftereverybeacon.Youcanenter

avaluefrom1through31.