Specifications

11-56 Access Point Commands
set radio-profile beacon-interval
Changestherateatwhicheachaccesspointradioinaradioprofileadvertisesitsserviceset
identifier(SSID).
Syntax
set radio-profile name beacon-interval interval
Parameters
Defaults
Thebeaconintervalforaccesspointradiosis100 msbydefault.
Mode
Enabled.
Usage
Youmustdisableallradiosthatare usingaradioprofilebeforeyoucanchangeparametersinthe
profile.Usethesetradio‐profilemodecommand
.
Example
Thefollowingcommandchangesthebeaconintervalforradioprofilerp1to200 ms:
RBT-8100# set radio-profile rp1 beacon-interval 200
success: change accepted.
Related Commands
• setradio‐profilemodeonpage 11‐63
• showradio‐profileonpage 11‐157
name Radioprofilename.
interval Numberofmilliseconds(ms)betweenbeacons.Youcanspecifyfrom25 ms
to8191 ms.