Specifications

RoamAbout Mobility System Software Command Line Reference 11-53
set radio-profile auto-tune power-interval
SetstheintervalatwhichRF Auto‐Tuningdecideswhethertochangethepowerlevelonradiosin
aradioprofile.Attheendofeachinterval,MSSprocessestheresults oftheRFscansperformed
duringthepreviousinterval,andchangesradiopowerlevelsifneeded.
Syntax
set radio-profile name auto-tune power-interval seconds
Parameters
Defaults
Thedefaultpowertuningintervalis300seconds.
Mode
Enabled.
Example
Thefollowingcommandsetsthepowerintervalforradiosinradioprofile rp2to240seconds:
RBT-8100# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
Related Commands
• set{ap|dap}radioau to‐tunemax‐poweronpage 11‐33
• setradio‐profileauto‐tunepower‐configonpage 11‐52
• setradio‐profileauto‐tunepower‐lockdownonpage 11‐54
• setradio‐profileauto‐tunepower‐ramp‐intervalonpage 11‐55
• showradio‐profileonpage 11‐157
name Radio
profilename.
seconds NumberofsecondsMSSwaitsbeforechangingradiopowerlevelstoadjust
toRFchanges,ifneeded.Youcanspecify from1to65535seconds.