Specifications

11-52 Access Point Commands
set radio-profile auto-tune power-config
Enablesordisablesdynamicpowertuning(RF Auto‐Tu ning)fortheaccesspointradiosinaradio
profile.
Syntax
set radio-profile name auto-tune power-config {enable | disable}
Parameters
Defaults
Dynamicpowerassignmentisdisabledbydefault.
Mode
Enabled.
Usage
WhenRF Auto‐Tuningforpowerisdisabled,MSSdoesnotdynamicallysetthepowerlevels
whenradiosarefirstenabledandalsodoesnottunepowerduringoperationwithassociated
clients.
WhenRF Auto‐Tuningforpowerisenabled,MSSdoesnotallowyoutomanuallychangethe 
powerlevel.
Example
Thefollowingcommandenablesdynamicpowertuningforradiosintherp2radioprofile:
RBT-8100# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
Related Commands
• set{ap|dap}radioau to‐tunemax‐poweronpage 11‐33
• setradio‐profileauto‐tunechannel‐configonpage 11‐46
• setradio‐profileauto‐tunepower‐intervalonpage 11‐53
• setradio‐profileauto‐tunechannel‐lockdownonpage 11‐50
• setradio‐profileauto‐tunepower‐lockdownon
page 11‐54
• showradio‐profileonpage 11‐157
name Radioprofilename.
enable Configuresradiostodynamicallysettheirpowerlevelswhentheaccess
pointsarestarted.
disable Configuresradiostousetheirstaticallyassignedpowerlevels,orthe
defaultpowerlevelsifunassigned,whentheradiosarestarted.